subject
Engineering, 12.08.2020 08:01 NeonPlaySword

A mixture of five (5) components are to be separated via four (4) unit operations. Below mention table shows the flow rate of each component, and the split ratio of the substances at each unit operation. a. Discuss your strategy to obtain the highest purity of substance A based on mass transfer and separation process principles.
b. Draw one (l) possible arrangements Of the separator to accomplish the objective in (a) in the form of a process now diagram
c. Estimate the purity of substance A in percentage (%)
d. If the final separator used to obtain the high purity substance A in (b) is a distillation column, estimate the minimum number of stages when the binary system is benzene- toluene.
e. If the final separator used to obtain the high purity substance A in (b) is a membrane column, determine the effects of varying the feed pressure on the mass flux of substance A across the membrane. Discuss your answer with relation to mass transfer principles. Take the permeability (g/m^2.min. atm) equals to the separation factor, and the pressure drop across the membrane to be only 2% of the feed pressure. Choose your own range of feed pressure.

Substance Flow rate (g/min) Separator 1 Separator 2 Separator 3 Separator 4
A 50 0.01 0.55 0.03 0.45
B 34 0.45 0.07 0.01 0.9
C 100 0.8 0.5 0.02 0.70
D 26 0.6 0.06 0.015 0.1
E 17 0.4 0.6 0.7 0.6

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, danksans7011
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
image
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
image
Engineering, 04.07.2019 18:10, nandalabella06
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
You know the right answer?
A mixture of five (5) components are to be separated via four (4) unit operations. Below mention tab...

Questions in other subjects:

Konu
Mathematics, 25.06.2019 20:00