Engineering, 12.08.2020 04:01 palmsalt05

chain sprocket system is designed to drive a shaft. Assume the following conditions: i. Use SAE 1018 steel for the key (which is the weakest material in comparison to other components) ii. The chain sprocket has a bore diameter of 2.5" and the hub length of 3.125" ill. The sprocket delivers 110 horsepower to a shaft with the rotation of 1700 rpm. iv. Safety factor of 3 Determine 1). The dimensions of the square key: Width: Minimum length (so the key will not fail): 2). The minimum contact length on the hub (so the hub will not fail);

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

You know the right answer?

chain sprocket system is designed to drive a shaft. Assume the following conditions: i. Use SAE 1018...