Engineering, 12.08.2020 06:01 kcruz87

A syringe pump is often used to pump small precise volumes of liquids. Imagine you are given a faulty syringe pump to use in the lab. The pump leaks at a rate of 15% whatever the flowrate out of the nozzle Qn. The syringe has a diameter (Ds) of 30 mm, a length of 120 mm and a nozzle diameter (Dn) of 3 mm. For your experiment, a nozzle flowrate of 1 milliliters/s is required. Answer the following questions: Required:
a. At what rate do you need to program the plunger velocity (Vp) to ensure you achieve the targeted flowrate (in mm/s)?
b. How long will you be able to maintain this flowrate (in min)?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

You know the right answer?

A syringe pump is often used to pump small precise volumes of liquids. Imagine you are given a fault...