Engineering, 04.08.2020 17:01 lolweapon

A temperature measurement system was used to measure the temperature of gases exiting a heating unit. The measurement system has the characteristics shown in the table below. The data from 10 measurements are shown in the other table below. Using these data, calculate the 95% uncertainty interval for the mean temperature of the population. Linearity ± 1 K over range Hysteresis ± 1 K over range Repeatability ± 2 K over range Resolution ± 0.5 K over range Digitization 16 bits Range 800 K to 1500 KExperimental Data:i Ti(K)1 11082 10733 10954 10855 11096 11047 11238 10789 107510 1095

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

You know the right answer?

A temperature measurement system was used to measure the temperature of gases exiting a heating unit...