Engineering, 04.08.2020 14:01 arthurdolz
A cast steel pinion (0o = 120 MNm2) rotating at 315 rpm drives a cast steel gear of a different grade (0o = 135 MNm-2) at a velocity ratio
of 3.0 to 1.
The pinion has 24 teeth, a module of 6 mm and the pressure angle is 200. Given all the previous calculations, is the dynamic load less
than the allowable wear load?
True
Or
False
Answers: 1
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 19:10, shunna33
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
A cast steel pinion (0o = 120 MNm2) rotating at 315 rpm drives a cast steel gear of a different grad...
Physics, 29.05.2020 02:00
Mathematics, 29.05.2020 02:00
Advanced Placement (AP), 29.05.2020 02:00