Engineering, 29.07.2020 17:01 tordiacasey

A Brayton-refrigeration cycle with a regenerative heat exchanger operates with a compressor and turbine at 86% efficiency. The compressor receives air at 480°R, 14.7 psi which is compressed to 40 psi. Compressed air enters the regenerative heat exchanger at 540°R and cools down to 480°R before entering the turbine. If the refrigeration capacity is 15 tons, calculate: the volume flow rates entering the compressor and turbine. the coefficient of performance.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

Engineering, 04.07.2019 19:10, shayshay7874

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

You know the right answer?

A Brayton-refrigeration cycle with a regenerative heat exchanger operates with a compressor and turb...