subject
Engineering, 25.07.2020 19:01 achasengnou792

1) Mathematically write 2nd Law (for all type of systems) using 3 symbols2) Entropy, s , is an intensive thermodynamic property T or F 3) Eliminate Sgen to minimize Wout of power cycle and maximize Win of heat pump T or F 4) For a specified inlet state, exit pressure, and mass flow rate, the power input to a compressor operating at steady state is less than what would be required if the compression occurred isentropically. T or F 5) For a specified inlet state, exit pressure, and mass flow rate, the power developed by a turbine operating at steady state is more than if the expansion occurred isentropically. T or F 6) The Carnot cycle analyzed in problem 6.169 produces entropy, Sgen > 0 T or F 7) The boiler and condenser in problem 6.169 produces entropy, Sgen > 0 T or F 8) The mixing of two streams of water at different temperature in a mixing tee (i. e. kitchen faucet) is an irreversible process, and produces entropy, Sgen > 0 T or F 9) Entropy generation, Sgen , is an intensive thermodynamic property T or F

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, theamandawhite
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
image
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
image
Engineering, 04.07.2019 18:10, wirchakethan23
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
image
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
1) Mathematically write 2nd Law (for all type of systems) using 3 symbols2) Entropy, s , is an inten...

Questions in other subjects: