Engineering, 15.07.2020 01:01 aspenwheeler6804

A very long, tightly-wound solenoid has a circular cross section of radius r = 2.6 cm. The magnetic field outside the solenoid is negligible. Throughout the inside of the solenoid the magnetic field B is uniform, but varying with time t: B = [0.07 + 0.03t2] tesla. Surrounding the circular solenoid is a loop of N = 3 turns of wire in the shape of a rectangle 10 cm high by 16 cm wide. The total resistance of the 3-turn loop is 0.1 ohm. Required:
At t = 3.7 seconds, what is the magnitude of the current in the 3-turn loop? (Hint: remember that the magnetic field is negligible in the region outside the solenoid.)

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 19:10, phantomlizz3233

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

continue

You know the right answer?

A very long, tightly-wound solenoid has a circular cross section of radius r = 2.6 cm. The magnetic...