Engineering, 15.07.2020 01:01 heysorryguys

Draw the and translate
chart beginn
The room
The following data apply to an A/C unit. Room sensible heat and latent heat are
11.6kW and 11.6 kW respectively, inside condition is 25°C DBT, 50% RH. Outside
design condition is 35 °C DBT and 27.8 °C, return air from the room is mixed with
outside air in the ratio of 4:1 before entering the cooler coil. Return air from the room
is mixed with the air leaving the coil in the ratio of 1:4. cooling coil bypass factor 0.1,
the air may reheated if necessary before supply to the room. Coil temperature is 10
°C. find a-supply air condition b- refrigeration load due to reheat c- total refrigeration
load capacity d- the quantity of fresh air supplied.
RSH. There
M2. sincet
we should
till this lir
intersectior
supply con
S
O MTW Mall
25°C, 50%
Qs=11.6
QI=11.6
R
R
R

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

You know the right answer?

Draw the and translate
chart beginn
The room
The following data apply to an A/C unit...