Engineering, 13.07.2020 20:01 iixyloa

Calculate the maximum intensity of the distributed load w, measured in kN/m, that the beam in Figure 3 can support. Given the angle of orientation at the middle portion of beam and
reactions of the supports are tabulated in Table 3.
Table 3: Angle of Orientation of Beam and Reactions at A and B
Forces/ Couples
Values
Unit
X
1.0
X2
3.0
Xi
5.0
0
20
VA
4
KN
Vg
KN
X1
X2
X3

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

You know the right answer?

Calculate the maximum intensity of the distributed load w, measured in kN/m, that the beam in Figur...