Engineering, 05.07.2020 01:01 604341

A Small-sized Wind Turbine is schematically shown in Fig (a), and is delivering a maximum rated power of ( 50 KW ). This Wind Turbine is using " A Single-Stage- Spur- gearbox " to speed up the main Drive shaft speed from 20 rpm to 1400 rpm ( see Fig (b) ). In order to absorb shock loads , such gear box is suspended in space by two torque arms -as shown in Fig ( c ); which is attached to the turbine housing by a Bolted Joint, of 6 equally spaced Hexagonal bolts. requirements:

1- The Standard Design Procedure

2-Design of Torque arm,

3-Design of the Bolted Joint

4-Design of the used Spur gear Pair

5-Design of main Input Shaft together with its KEY

6-Select the Right Deep Groove Ball bearings; which are supporting the main input Shaft, and Finally

7-The Configuration of the Main Input Shaft (Product Concept, DFM, DFA, Dimensions, Fits, and Tolerances for mating parts)

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, danksans7011

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:20, luisgonz5050

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

continue

You know the right answer?

A Small-sized Wind Turbine is schematically shown in Fig (a), and is delivering a maximum rated powe...