Engineering, 05.07.2020 14:01 blakestuhan
For 120 consecutive days, a process engineer has measured the weight and examined the surface for imperfections of a component after it has been coated with a special paint. Each day, she takes a sample of 45 components. Across all sampled parts, the average weight is 112 grams, the standard deviation of weight is 0.16 gram, and there are in total 103 parts with surface imperfections. Round your answer to 4 digits after the decimal point if it is not an integer. Do NOT use comma in your numeric answers. Sample size is .Number of samples is .When constructing a x-bar chart:The center line should be .ESD(x-bar) equals .The upper control limit (UCL) should be .The lower control limit (LCL) should be .When constructing a p chart:The center line should be .ESD(p) equals .The upper control limit (UCL) should be .The lower control limit (LCL) should be
Answers: 1
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
For 120 consecutive days, a process engineer has measured the weight and examined the surface for im...
Chemistry, 21.01.2021 19:20
Mathematics, 21.01.2021 19:20
Mathematics, 21.01.2021 19:20
Mathematics, 21.01.2021 19:20
Mathematics, 21.01.2021 19:20
Mathematics, 21.01.2021 19:20
French, 21.01.2021 19:20
Social Studies, 21.01.2021 19:20
English, 21.01.2021 19:20