Engineering, 05.07.2020 01:01 mine9226

A particular part is being turned on a lathe. The diameter of the part is supposed to be 20,000 mm. The diameter is measured every 10 minutes and the results are stored in a file called partdiam. dat. Create a data file to simulate this. The file will store the time in minutes and the diameter at each time. Plot the data

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 05.07.2019 19:10, justin20080

Tech a says never use a water hose to clean up dust after a repair. tech b says never use a floor scrubber to clean up dust after repairs. who is correct?

Answers: 1

continue

Engineering, 06.07.2019 03:20, shelbellingswo

Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.

Answers: 2

continue

You know the right answer?

A particular part is being turned on a lathe. The diameter of the part is supposed to be 20,000 mm....