subject
Engineering, 04.07.2020 01:01 22chandlerlashley

Consider the free energy functional of an inhomogeneous system that depends on a non-conserved order parameter η and temperature T, written in one-dimension as: G= ∫ [Go+ α [T- Tc]η^2 + Cη^3+ Bη^4+ D(∂η/∂η)^2 ].dx

Tc is the critical temperature.

Required:
a. Plot the equilibrium value of the order parameter as a function of temperature for a homogeneous system both for cases of constant C ≠ 0 and for vanishing C as T passes through the critical temperature. Choose representative values or ratios of the coefficients, you should not need particular values.

b. Explain how, using the free energy functional above and Gibbs' definition of the surface properties you would construct an expression for the surface en- ergy/surface tension of an interface separating an infinite ordered phase η = 1 and an infinite disordered phase η = 0.

c. Explain how and why the diffraction patterns (intensity vs. angle) change as a material alloy in going from ordered to disordered state. Can these patterns be used to investigate the kinetics of ordering?

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, theamandawhite
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
image
Engineering, 04.07.2019 18:10, hadellolo8839
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
image
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
image
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
You know the right answer?
Consider the free energy functional of an inhomogeneous system that depends on a non-conserved order...

Questions in other subjects: