Engineering, 27.06.2020 22:01 dlatricewilcoxp0tsdw

Technician A says that shock absorbers should be replaced in pairs. Technician B says that gas shocks should be bled before installation.
Who is right?
O A only
O Bonly
O Both A and B
O Neither Anor B
Previous
Exact answer

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 19:10, phantomlizz3233

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

continue

Engineering, 04.07.2019 19:10, Lexi5170

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b. s. and b. s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

continue

Engineering, 04.07.2019 19:20, amandaaarmentaa

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

continue

You know the right answer?

Technician A says that shock absorbers should be replaced in pairs. Technician B says that gas shoc...