Engineering, 27.06.2020 02:01 DaFuzzyDude

The center-to-center distance from reference hole A to hole B is 3.00"+/-0.11". Hole A will be ø(4.0"+/-0.1"). If a jig is to be used to locate hole B by inserting a locator pin in hole A of ø(3.85"+/-0.05"), due to the slack between the jig locator pin and hole A: a. What are the potential limits in the location of hole B? b. Are these potential limits acceptable? c. If the potential limits are not acceptable, how would you make them acceptable? In part c, a bushing will be used to make hole B. What should be the specification for bushing location tolerance?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, pjgolden04

How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?

Answers: 2

continue

You know the right answer?

The center-to-center distance from reference hole A to hole B is 3.00"+/-0.11". Hole A will be ø(4.0...