subject
Engineering, 24.06.2020 04:01 irene4523

Carry generate (G) and carry propagate (P) are defined as follows: G =AB and P = A  B. a) Show the expressions for Sum and Carry-out of a 1-bit Full Adder (1bFA) in terms of Carry-In, P and G. b) Design the 1b FA with any number of 2-to-1 multiplexers and logic gates. Show the schematic with inputs A, B, Carry-in and outputs Sum and Carry-out. c) Estimate the following propagation delays for your schematic: • Carry-in to Carry-out (t1), • Data-to-Carry-out (t2), • Carry-in to sum (t3).Assume the following propagation delays for 2-to-1mux: data D1, DO to output Y: 5 ns; select S to output Y: 10 ns. Assume a 10 ns delay for logic gates, a 5 ns delay for inverters.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, margaret1758
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
image
Engineering, 04.07.2019 18:10, chadatkin
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
image
Engineering, 04.07.2019 18:10, jojoangelique13
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
Carry generate (G) and carry propagate (P) are defined as follows: G =AB and P = A  B. a) Show th...

Questions in other subjects:

Konu
Mathematics, 10.12.2020 01:00