Engineering, 22.06.2020 00:57 CarlsonB

WHAT IS A TOROID IN HYDRAULUCS?

Answers: 1

Show answers

Answers

A hydraulic actuator comprised of a toroidal piston within a toroidal enclosure, with differential fluid pressure alternatively applied to upper and lower surfaces of the piston to cause a reciprocating motion, and with plural double ended piston rods extending in parallel above and below the piston, and slidably extending in fluid sealed relation through end caps of the toroidal enclosure to distribute the vibrational force produced by the reciprocating piston over plural points of a surface area of the mass to be vibrated, thereby reducing the likelihood of stress, strain, or harmonics in the mass.

Answer from: jaylenmiller437

Expl

Answer from: Quest

The main difference between gui and cli is that the graphical user interface (gui) allows the user to interact with the system using graphical elements such as windows, icons, menus while the command line interface (cli) allows the user to interact with the system using commands

Answer from: Quest

unlike the threaded fasteners which are used to clamp the machine members, power screws are used to transmit power. common applications of power screws are: screw jacks: to lift weight. lead screw of lathe: for axial movement of tool and its precise positioning.

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 19:10, brid7931

Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates

Answers: 3

continue

Engineering, 04.07.2019 19:20, anggar20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

continue

Engineering, 04.07.2019 19:20, ameliaxbowen7