Engineering, 18.06.2020 00:57 redrosesxx

Inductor was made using a PVC pipe with a diameter of 0.625 inches, 100 turns and the width of the windings along the length of the inductor was measured to equal 0.255 inches. a. Calculate the theoretical inductance of this inductor recognizing that Î¼o=4Ï€âˆ™10^-7 H/m and that Î¼râ‰ˆ1 for air.
b. The magnetic wire used for the windings was made out of copper (sigma = 5.96 x10^7 S/m). The diameter of the wire was measured to be 4x10^-3 inches in diameter. Calculate the theoretical resistance of the copper wire used to make the inductor. How does your calculated value compare to the measured value of 13.6 Ohm?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

You know the right answer?

Inductor was made using a PVC pipe with a diameter of 0.625 inches, 100 turns and the width of the w...