Engineering, 06.06.2020 16:57 NicoleQuinn

Is = 2A, Vs = 5V, R_1 = 50 Ohm, R_2 = 50 Ohm, R_3 = 100 Ohm, R_4 = 100 Ohm Use MESH ANALYSIS to calculate the current i_1 flowing through resistor R1. Enter only the numerical answer for i_1 in the text box. Only round the final answer and round to three decimal places. Do not include the units (Amps). 0.683 For the same circuit, calculate the current i_3 flowing through resistor R3. Enter only the numerical answer for R_3 in the text box. Only round the final answer and round to three decimal places. Do not include the units (Amps).

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

You know the right answer?

Is = 2A, Vs = 5V, R_1 = 50 Ohm, R_2 = 50 Ohm, R_3 = 100 Ohm, R_4 = 100 Ohm Use MESH ANALYSIS to calc...