subject
Engineering, 05.06.2020 05:02 kj44

Choose the most appropriate answer in each of the following cases (with a brief justification). A: Given a channel capacity C shared by N stations that generate data at maximum rates, the CDMA-based transmission of data using M-chip code sequences allows each station to enjoy an effective transmission bandwidth share B, where: (i) B ≈ C N (ii) B ≈ C M (iii) B → C(−) (iv) B ≈ C N+M

B: IEEE 802.3 Ethernet (CSMA/CD) specifies a minimum data packet size, because: (i) Applications always generate large sized data packets (ii) Channel efficiency increases by amortizing the header overhead across a certain minimum packet size (iii) The sender of a packet should transmit long enough to hear any collisions that may occur at the farthest end of bus (iv) The application programming becomes simpler by sending a less number of large-sized packets

C: In comparison to transmission over a wired network, the signal strength over a wireless network decays rapidly with respect to the distance of receiver, because: (i) Signal energy propagates faster over wireless medium than over wired medium (ii) Signal energy propagates in all directions over wireless medium, whereas energy propagates only in the direction of wired medium; (iii) Noise signals are stronger in wireless medium that in wired medium (iv) Signal is sent on a high frequency carrier over wireless medium, whereas signal is sent as baseband over wired medium.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 04.07.2019 18:10, jojoangelique13
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
image
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Choose the most appropriate answer in each of the following cases (with a brief justification). A:...

Questions in other subjects:

Konu
Mathematics, 02.09.2019 00:50
Konu
Mathematics, 02.09.2019 00:50