Engineering, 05.06.2020 15:59 lburch112
Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 800 kpa and the temperature is 40 c to give mach no 2.5 the throat are for the nozzle is .0025 m^{2}
1- The flow rate through the nozzle under design conditions
2- The exit area of the nozzle
3- The design back-pressure and the temperature of air leaving nozzle with this back pressure
4-The lowest back-pressure for which there is only subsonic flow in the nozzle
5- The back-pressure at which there is a normal shock wave on the exit plane of nozzle
6- The back-pressure below which there are no shock waves in the nozzle
7-The range of back-pressures over which there are oblique shock waves in the exhaust from the nozzle
8- The range of back-pressures over which there are expansion waves in the exhaust from the nozzle
9- The back-pressure at which a normal shock wave occurs in the divergent section of the nozzle at a point where the nozzle area is half way between throat and exit plane the throat and exit plane areas.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:20, AnonymousLizard52303
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
Engineering, 04.07.2019 19:20, diawia
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
Engineering, 05.07.2019 04:30, kookycookiefanx
Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?
Answers: 2
You know the right answer?
Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 8...
Questions in other subjects:
Computers and Technology, 30.08.2019 22:10
