Engineering, 02.06.2020 15:57 lilquongohard

A circular rod is attached to a wall. It has three gears (1, 2, 3).
Gear 1 is located D inches away from the wall.
Gear 2 is E inches away from Gear A.
Gear 3 is A + B inches away from Gear B.
The torque applied to Gear 1 is A kip-ft, Gear 2 is B kip-ft, Gear 3 is C kip-ft.
If the value of A, B,C is even the torque is positive, if odd the torque is negative.
The outdoor diameter is your largest number in centimeters. The inner diameter is your smallest number in centimeter. Make sure to convert to appropriate units.
The rod is made from Red Brass C83400 from the wall to Gear 1, Structural A-36 Steel from Gear 1 to Gear 2, and Magnesium Alloy Am 1004-T61 from Gear 2 to Gear 3.
a. Draw your diagram with clearly labeled distances, torques, etc.
b. Calculate the maximum shear stress for the three different materials.
c. How many degrees and in which direction does gear three turn in relation to the wall when all three torques are applied?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 19:10, Lexi5170

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b. s. and b. s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

continue

Engineering, 04.07.2019 19:20, Katmcfee7681

Acommercial grade cubical freezer, 4 m on a side, has a composite wall consisting of an exterior sheet of 5.0-mm thick plain carbon steel (kst= 60.5 w/m k), an intermediate layer of 100-mm thick polyurethane insulation (kins 0.02 w/m k), and an inner sheet of 5.0- mm thick aluminium alloy (kal polyurethane insulation and both metallic sheets are each characterized by a thermal contact resistance of r 2.5 x 104 m2 k/w. (a) what is the steady-state cooling load that must be maintained by the refrigerator under conditions for which the outer and inner surface temperatures are 25°c and -5°c, respectively? (b) for power saving purpose, which wall material should be increased/reduced in. thickness in order to reduce 50% of the cooling load found in part (a)? redesign the thickness of the proposed material. 177 w/m-k). adhesive interfaces between the q=575.93 w

Answers: 2

continue

You know the right answer?

A circular rod is attached to a wall. It has three gears (1, 2, 3).
Gear 1 is located D inche...