Engineering, 29.05.2020 15:57 ghernadez

A large truck drives down the highway at 10 m/s hauling a rectangular trailer that is 6 m long, 2 m wide, and 2 m tall. The trailer contains frozen food and is therefore temperature-controlled. Its external surface can be approximated to be a consistent 15°C, while the outside air is at 20°C. Assume the heat transfer on the front, back, and bottom of the trailer is negligible.

a) How much cooling power must be provided to maintain the temperature controlled trailer? (i. e. What is the total heat transfer rate from the air to the trailer)?b) What is the minimum local heat transfer coefficient on the surface of the trailer? Where does the minimum occur?c) What percentage of the total heat transfer is occuring over a laminar boundary layer?d) If the cooling system can only provide 5 KW of cooling, what is the fastest speed that this truck can drive while still adequately maintaining the temperature within the trailer?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

You know the right answer?

A large truck drives down the highway at 10 m/s hauling a rectangular trailer that is 6 m long, 2 m...