Engineering, 27.05.2020 20:58 milkshakegrande101
5. Technician A says to repack each bearing with fresh grease by pushing it into the larger side of the bearing assembly until it forces out of the bearing.
Technician B says to place the equivalent of 3 tablespoons to 4 tablespoons of grease in the center of the hub. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technician A and B
D. Neither Technician A nor B
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 19:10, moneyyfletcher
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Engineering, 04.07.2019 19:10, shayshay7874
An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling
Answers: 2
Engineering, 06.07.2019 03:20, carrietaylor234
Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?
Answers: 3
You know the right answer?
5. Technician A says to repack each bearing with fresh grease by pushing it into the larger side of...
Questions in other subjects:
Biology, 31.07.2019 17:30
Business, 31.07.2019 17:30
Mathematics, 31.07.2019 17:30
History, 31.07.2019 17:30
