Engineering, 27.05.2020 15:57 armando87
Simple flow works according to the simple Brayton cycle. The air enters the compressor with 80 kPa pressure, 280 K temperature and 55 m3 / h volumetric flow. The pressure ratio in the compressor is 20, the maximum temperature in the cycle is 2100K. As the compressor will have an isentropic efficiency of 93%, a turbine of 96% and a cold air standard.
a) Net power, MW
b) Heat transfer in the boiler, MW
c) Thermal efficiency of the cycle
d) If it is considered to use heat transfer at 2500 K temperature, find the entropy production in the boiler by writing the 2nd law (entropy balance).
Answers: 3
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, krystabrewer3
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
Simple flow works according to the simple Brayton cycle. The air enters the compressor with 80 kPa p...
Mathematics, 15.10.2019 05:00
Mathematics, 15.10.2019 05:00