Engineering, 24.05.2020 00:01 nathanbarbry

For this problem, you are to design a simple combinational logic circuit and then use Logisim to simulate and test the circuit. The circuit is a 2-bit priority encoder with inputs X2 and X1 and outputs Y1 and Y0 .

The circuit behaves as follows:

o If X2X1 = 00, then Y1Y0 = 00 (no active input)

o If X2X1 = 01, then Y1Y0 = 01 (low-priority input, X1, is active)

o If X2X1 = 1-, then Y1Y0 = 10 (high-priority input, X2, is active)

Note that the value of input X1 does not matter if the high-priority input, X2 , is active. Also, output combination Y1Y0 = 11 should never occur.

a. Give the truth table that shows outputs Y1 and Y0 as functions of inputs X2 and X1 .

b. Give the Boolean algebra expressions for output Y1 and output Y0 .

c. Simulate your circuit using Logisim. Label all inputs and the output. Test for all four input combinations. Insert a picture of the circuit, as drawn in Logisim, into your homework submission.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

You know the right answer?

For this problem, you are to design a simple combinational logic circuit and then use Logisim to sim...