Engineering, 21.05.2020 20:04 kcameronanderso

When using levers like scissors or hedge clippers, what can be done to increase the cutting force so that you don’t have to squeeze so hard?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

You know the right answer?

When using levers like scissors or hedge clippers, what can be done to increase the cutting force so...