Engineering, 13.05.2020 05:57 hjlhdjfhjh

20-tooth spur pinion has a diametral pitch of 6 teeth/inch and a quality standard of No 6. When the pinion rotates at 1150 rev/min, the AGMA factors of safety for bending and contact are 3 and 5, respectively. (a) If the speed is increased to 2300 rev/min, what are the AGMA factors of safety for bending and contact? (b) Is bending or contact the primary failure mode for this gear? Provide evidence with calculated values

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, dval1146

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

You know the right answer?

20-tooth spur pinion has a diametral pitch of 6 teeth/inch and a quality standard of No 6. When the...