Engineering, 09.05.2020 03:57 qwerty8364

We want to compare the performance of a switch (L2) versus a router (L3) in terms of the average packet delay. In both, we use the same hardware that consists of a processor that runs at 1 Gbps (2 30 bps). The switch accepts 1 KB (2 10B) fixed size packets. The router accepts variable size packets with an average 1 KB. In both scenarios, packets arrive at a rate λ = 64 packets/s.
(a) What is the service rate (µ), in terms of packets/s, at each port for the switch and the router? 4 pts
(b) What is the traffic intensity (service utilization, rho) at each port for the switch and the router? 4 pts
(c) What is the average queuing delay for the switching port? 4 pts
(d) What is the average queuing delay for the router port? 4 pts
(e) Which one is faster and by how much?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:20, rhussein6452

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

continue

Engineering, 04.07.2019 19:10, Lexi5170

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b. s. and b. s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

continue

You know the right answer?

We want to compare the performance of a switch (L2) versus a router (L3) in terms of the average pac...