Engineering, 07.05.2020 04:02 hanjonez

Question #11 Multiple Choice
Based on the following passage, which of the following is likely true of ironworkers?
Ironworkers have constructed some of the country's most beloved landmarks, from the
Golden Gate Bridge to the St. Louis Arch. Because the work can be dangerous and
requires erens to trust and rely on each other, ironworkers often develop a special
camarader. When a building is "topped out," that is when the final beam is put into
place, ironworkers often celebrate by signing the beam and then hanging a flag or banner
from it
They comprise a relatively new industry.
They are highly independent
They prefer to work on landmarks instead of buildings.
They take special pride in their work

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

You know the right answer?

Question #11 Multiple Choice
Based on the following passage, which of the following is likely...