subject
Engineering, 05.05.2020 20:46 rsloan13

The isentropic efficiency of the turbine in a steam power plant is 80%. The power output of the turbine is 30 MW. Steam exits the boiler and enters the turbine at 8 MPa and 500o C and exits the turbine to the condenser at 20 kPa. Steam exits the condenser as saturated liquid and is pumped back to the boiler employing a water pump. Assume State 1 to be the state of water entering the pump and State 2 to be the state of water leaving the pump and compute the following: (a) the steam mass flow rate through the turbine, (b) the condenser heat rejection rate, (c) the power consumed by the pump, (d) the enthalpy of the state of water leaving the pump, (e) the cycle thermal efficiency, and (f) the rate of entropy generation in the condenser if the ambient temperature is 10o C. Assume that the pumping process in the pump is isentropic.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 19:30, 10040813
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
image
Engineering, 04.07.2019 18:20, samueltaye
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
You know the right answer?
The isentropic efficiency of the turbine in a steam power plant is 80%. The power output of the turb...

Questions in other subjects: