Engineering, 05.05.2020 04:38 rutza

The following data was measured in the cross-flow heat exchanger experiment using a single rod. Inlet Air Temperature (C) (Tin and T\infty): 27 Outlet Air Temperature (C): 28Average Inlet Air Velocity (m/s): 10 Heating Element Temperature (C): 550Given: The area of cross section is 0.02286 m2. The diameter and the length of the rod are 0.0125 m and 0.10795 m, respectively. Assume (air): CP = 1007 J/kg-K), Density=1.1614 kg/m3, u=184.6x10-7 (N s/m2 ) Calculate the average h and Nu. Discuss the major error sources.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:20, samantha636

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

Engineering, 04.07.2019 19:10, gabrielaperezcz

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

continue

You know the right answer?

The following data was measured in the cross-flow heat exchanger experiment using a single rod. Inle...