Engineering, 05.05.2020 04:09 diegocazador67

You are asked to select a bearing.
The radial force on the bearing is estimated as 300 lbf. The rotation speed of the shaft is to be 500 rpm and the life to be 45 kh with a reliability of 0.95.
a) What is the C10 catalog entry (in lbf) to be sought when searching for a deep-groove bearing in a manufacturer's catalog on the basis of one million revolutions for raiting life?
Use the Weibull parameters: x0 = 0.02, (θ- x0) = 4.4, and b = 1.5. Also use an application factor of 1.25.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, yasyyas646646

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

continue

Engineering, 04.07.2019 19:10, nida7864

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

continue

You know the right answer?

You are asked to select a bearing.
The radial force on the bearing is estimated as 300 lbf. T...