Engineering, 05.05.2020 09:20 whocares1234

Work and heat transfer calculation in a closed system

Find the pressure, temperature and volume at the end of each of the four processes. Then calculate the work done during each process and the net amount of work done. Finally calculate the net amount of heat transfer comparing the very initial and the very final states.

Nitrogen T1 (°C): 90, P1 (kPa): 530, m(kg): 9.3

process1: Isobaric expansion and the volume increased by 70%

process2: Isothermal expansion to a pressure of 10% of the initial pressure.

process3: Polytrpic comprission with n = 1.2 to the same initial process.

process4: Isochoric cooling to reach a pressure equal to 40% of the initial pressure

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

You know the right answer?

Work and heat transfer calculation in a closed system

Find the pressure, temperature and...