Engineering, 06.05.2020 02:06 Mumi2232

To be able to describe the motion of rigid bodies by applying the conservation of linear and angular momenta. If the sum of all the linear impulses acting on a system of connected rigid bodies is zero, the linear momentum of the system is conserved. Mathematically, this relationship is expressed as (∑syst. linearmomentum)1=(∑syst. linearmomentum)2 and is called the conservation of linear momentum. If the sum of all the angular impulses (created by the external forces that act on the system) is negligible or zero, then the angular momentum of a system of connected rigid bodies is conserved about the system's center of mass or about a fixed point. Mathematically, this relationship is expressed as (∑syst. angularmomentum)1=(∑syst. angularmomentum)2 and is called the conservation of angular momentum.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

You know the right answer?

To be able to describe the motion of rigid bodies by applying the conservation of linear and angular...