Engineering, 06.05.2020 08:34 haileyhale5

A member of a loaded truss is cut by an imaginary plane as indicated below. If the cross sectionalarea is 10 in2, the magnitude of the force is 100 kips and the orientation of the angle is 45❦from thex axis, determine the following information:(a) Determine ϝxx, ϝyyand ϝxyat point A.(b) Plot Mohrcircle for the stress state at point A.(c) Find the principal stresses and the maximum in-plane shear stress.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 19:10, santosbeti90

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

continue

You know the right answer?

A member of a loaded truss is cut by an imaginary plane as indicated below. If the cross sectionalar...