subject
Engineering, 25.04.2020 05:01 igobeastmode

Asolid rectangular rodhas a length of 90mm, made of steel material (E =207,000 MPa, Syield= 300 MPa), the cross section of the rod is shownbelow. If the boundary conditions are fixed-freeand a safety factor of 2 on loadis required, (1)Find themaximumallowable load (Pallowable)on the rod. [9points]{hint: Pallowable= Pcr/required safety factor}(2)If the same critical load (Pcr) calculated from (1)above(Pcrisalready taken into accounta safety factor of 2)is applied to a solid round rodunderthe same boundary conditions, what is the minimum required diameter of the rod against buckling? [9points]

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, karatsgrande3772
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10รค1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
image
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
image
Engineering, 04.07.2019 19:10, pedropaulofpedrosapp
Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg. m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?
Answers: 3
image
Engineering, 06.07.2019 03:10, Bloom247
List and describe the attached tools in boxford cnc milling machine? and how many tools were used in your projects explain them?
Answers: 3
You know the right answer?
Asolid rectangular rodhas a length of 90mm, made of steel material (E =207,000 MPa, Syield= 300 MPa)...

Questions in other subjects:

Konu
Mathematics, 04.01.2021 23:20