Engineering, 25.04.2020 04:53 mprjug6

A commercial enclosed gear drive is to be designed. Initially, the following is specified. The drive is to transmit 5 hp with an input pinion speed of 300 rev/min. The drive is to consist of two spur gears, with a 20° pressure angle, and the pinion is to have 16 teeth driving a 48-tooth gear. The gears are to be grade 1 steel, through-hardened at 200 Brinell, made to No. 6 quality standards. The gears will be uncrowned, centered on their shafts between bearings. A pinion life of 108 cycles is desired, with a 90 percent reliability.
(a) Use a trial value of diametral pitch of 6 teeth/in and a face width of 2 in.
For the pinion, (i) determine the bending stress, allowable bending stress, and bending factor of safety. (ii) determine the contact stress, allowable contact stress, and contact factor of safety.
(b) Assume gears are readily available in face-width increments of 0.5 in, with face widths in the range of three to five times the circular pitch. Specify a diametral pitch and face width such that the minimum factor of safety for the pinion is equal to 2.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

You know the right answer?

A commercial enclosed gear drive is to be designed. Initially, the following is specified. The drive...