![subject](/tpl/images/cats/User.png)
Engineering, 25.04.2020 03:04 orangeicecream
Signal generator‘s internal impedance is purely resistive and has an open-circuit voltage of 3.5 V. When the generator is loaded with 22 ohms of resistance, its terminal voltage drops to 2.8 V. What is the generator’s output impedance (pure resistance)?
![ansver](/tpl/images/cats/User.png)
Answers: 1
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
Signal generator‘s internal impedance is purely resistive and has an open-circuit voltage of 3.5 V....
Questions in other subjects:
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 13.10.2020 05:01
![Konu](/tpl/images/cats/obshestvoznanie.png)
![Konu](/tpl/images/cats/ekonomika.png)
![Konu](/tpl/images/cats/biologiya.png)
Biology, 13.10.2020 05:01
![Konu](/tpl/images/cats/obshestvoznanie.png)
![Konu](/tpl/images/cats/obshestvoznanie.png)
Social Studies, 13.10.2020 05:01
![Konu](/tpl/images/cats/istoriya.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 13.10.2020 05:01