Engineering, 24.04.2020 20:31 ShortCakes02

Design a PID controller (using the tools from class) for the unity feedback system described in Project 2 such that setting time is reduced by a factor of 20 while maintaining a 5% overshoot, and a 0 steady-state error for a ramp input. Simulate the step and ramp response for the system from time 0 to 1. Do not worry if your %OS is not exactly 5%, we will accept up to a 20% overshoot. Nevertheless, you should get a good ramp response. Do not forget to report the gain and location of the zeros that you found. Include your derivations.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 19:20, nikkiebartels

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer, e = 5 × 105?

Answers: 2

continue

Engineering, 05.07.2019 23:20, neisha2507

Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket

Answers: 3

continue

Engineering, 06.07.2019 02:30, cofran

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

continue

You know the right answer?

Design a PID controller (using the tools from class) for the unity feedback system described in Proj...