Engineering, 24.04.2020 20:45 CooperIgou6566

The fuel of problem 4 was used to run a spark-ignition engine in a laboratory environment simulating the atmosphere of planet Mars. The intake air was composed of (O2 + 3CO2). Stoichiometric amounts of "air" and fuel enter the engine at 25°C, while combustion products in the exhaust manifold are at an average temperature of 1000 K. Only products of complete combustion are found in the exhaust. It is measured that the engine produces 2.0 kW of power while the heat transfer rate to the surroundings is 1.0 kW.

a) Determine the mass flow rate of the fuel supplied to the engine.

b) Determine the fuel conversion efficiency of the engine when operated with the proposed fuel.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, lowkeyqueenk

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

You know the right answer?

The fuel of problem 4 was used to run a spark-ignition engine in a laboratory environment simulating...