Engineering, 24.04.2020 00:16 july00
In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 6000 ft/min, work speed = 40 ft/min, infeed = 0.002 in, and crossfeed = 0.20 in. The number of active grits per square inch of wheel surface = 400. Determine
(a) the average length per chip,
(b) the metal removal rate
(c) the number of chips formed per unit and the average volume per chip?
(d) If the tangential cutting force on the workpiece is 50 lb, what is the specific energy calculated for this job?
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 19:10, santosbeti90
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
You know the right answer?
In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 60...
Questions in other subjects:
Advanced Placement (AP), 11.10.2019 06:30
Mathematics, 11.10.2019 06:30
Mathematics, 11.10.2019 06:30
Mathematics, 11.10.2019 06:30
