Engineering, 23.04.2020 23:12 Gattuso

Design1 a combined cycle power plant to generate a net power output of 550 MW. The maximum temperature of the Brayton cycle is 1150 K. Air intake condition is 100 kPa and 30°C. Condenser pressure of the Rankine cycle is 45 kPa. Boiler (heat exchanger) pressure of the Rankine cycle is 10 MPa. The isentropic efficiency of the gas turbine is 0.87 and that of the compressor is 0.85. Isentropic efficiency of the feedwater pump is 0.8, and that of the steam turbine is 0.81. Use constant specific heats for air at the inlet temperature to each component. Use EES to:

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

You know the right answer?

Design1 a combined cycle power plant to generate a net power output of 550 MW. The maximum temperatu...