Engineering, 22.04.2020 22:58 lennyatme

The pumping unit is used to recover oil. When the walking beam ABCABC is horizontal, the force acting in the wireline at the well head is FCFC = 250 lb. lb. Determine the torque MM which must be exerted by the motor in order to overcome this load. The horse-head CC weighs 61 lblb and has a center of gravity at GCGC. The walking beam ABCABC has a weight of 130 lblb and a center of gravity at GBGB, and the counterweight has a weight of 225 lblb and a center of gravity at GWGW. The pitman, ADAD, is pin connected at its ends and has negligible weight.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Engineering, 04.07.2019 19:20, molly7654

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

continue

Engineering, 06.07.2019 04:20, butt1562

Consider the transfer function for a first-order system g(s)=12(s+7)/(s^2+2s+9) for this system determine: a) poles and zeros of the function, b) the natural frequency and damping ratio, c) the peak value achieved in response to a unit step input, d) the peak time for a unit step input, e) the steady-state system response to a unit step input

Answers: 2

continue

You know the right answer?

The pumping unit is used to recover oil. When the walking beam ABCABC is horizontal, the force actin...