Engineering, 22.04.2020 22:31 caitlinrosekozoxegcb

There are two ingredients (A and B) that will be mixed in the reactor tank. Wait for READY signal to be on (when on, it signifies that QA Tank is ready for this batch). 2. To add the fixed amount of ingredient A to the mixing tank, VALVE_A needs to be on. To add the fixed amount of ingredient B to the mixing tank, VALVE_B needs to be on. Both VALVE_A and VALVE_B will be turned on for 10 seconds, then they need to be turned off automatically. 3. When material A is ready to be added, PULSE_A will be on. When material B is ready to be added, PULSE_B will be on. If the PULSE_A for material A (or PULSE_B for material B) is off, the material A cannot be added to the mixing tank even the VALVE_A is turned on. 4. After the materials are fed into the mixing tank, agitate and mix the materials at a high speed (500 rpm) by turning on the motor AGIT_ON_HS for 20 seconds. 5. After that, the agitate motor is then switch for a lower speed (200 rpm) by turning on the motor AGIT_ON_LS for 30 seconds.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, siri5645

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 04.07.2019 19:20, mercedesamatap21hx0

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

continue

You know the right answer?

There are two ingredients (A and B) that will be mixed in the reactor tank. Wait for READY signal to...