Engineering, 22.04.2020 16:29 dontcareanyonemo
In a turning operation on stainless steel with a hardness of 200 HB, the cutting speed is 200 m/min, feed is 0.25 mm/rev, and depth of cut is 7.5 mm. How much power will the lathe draw in performing this operation if its mechanical efficiency, E, is 90%. The specific energy value for the material is known to be 2.8 N-m/mm3
Answers: 1
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10, niicoleassssssf
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
In a turning operation on stainless steel with a hardness of 200 HB, the cutting speed is 200 m/min,...
Mathematics, 06.07.2021 19:10
Mathematics, 06.07.2021 19:10
Geography, 06.07.2021 19:10