Engineering, 22.04.2020 04:52 ciarrap552

6msection of 150lossless line is driven by a source with vg(t) = 5 cos(8π × 107t − 30◦ ) (V) and Zg = 150 . If the line, which has a relative permittivity r = 2.25, is terminated in a load ZL = (150 − j50) , determine: (a) λ on the line. ∗ (b) The reflection coefficient at the load. (c) The input impedance. (d) The input voltage Vi. (e) The time-domain input voltage vi(t).

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Engineering, 04.07.2019 19:10, LadyHolmes67

Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false

Answers: 3

continue

Engineering, 06.07.2019 04:20, hailiemanuel930

Steam enters a turbine at steady state at 2 mpa, 360°c with a velocity of 100 m/s. saturated vapor exits at 0.1 mpa and a velocity of 50 m/s. the elevation of the inlet is 3 m higher than at the exit. the mass flow rate of the steam is 15 kg/s, and the power developed is 7 mw. let g 9.81 m/s^2. determine: a)-the area at the inlet, in m^2 b)-the rate of heat transfer between the turbine and surroundings, in kw c)-draw a p-v diagram for this process.

Answers: 1

continue

Engineering, 06.07.2019 05:20, vaeh41

A8-in.-diameter steel shaft is to have a press fit with a 16-in-diameter cast iron hub. both the hub and the shaft are 10 in long. using maximum normal stress theorem and appropriate safety factor, it was identified that the maximum allowable circumferential (a. k.a. hoop or tangential) stress in the hub is to be 7.5 ksi. the moduli of elasticity are 30 x 106 psi for steel and 15 x 106 psi for cast iron. the poisson's ratio for both steel and cast ron is 0.3 and coefficient friction for the two materials is 0.12. determine a. the interference or the original mismatch, 8 b. the maximum axial force required to press the hub on the shaft

Answers: 1

continue

You know the right answer?

6msection of 150lossless line is driven by a source with vg(t) = 5 cos(8π × 107t − 30◦ ) (V) and Zg...