Engineering, 21.04.2020 15:28 glocurlsprinces

For beam design, the cross section dimensions of the beam are determined: A. Based on allowable normal stress, but the allowable shear stress should always be checked to be sure it is not exceeded. B. Based on the allowable shear stress, but the allowable normal stress should always be checked to be sure it is not exceeded. C. Such that both the allowable normal stress and the allowable shear stress are reached at the same time. D. Based on the allowable normal stress. E. The allowable shear stress is not an important design consideration.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

You know the right answer?

For beam design, the cross section dimensions of the beam are determined: A. Based on allowable norm...