subject
Engineering, 21.04.2020 15:25 khristaviaaa

Consider the simplicity of these two DOE examples. Next, consider the assertion that DOE isn’t put into practice as often or deeply as experts feel it should be. Describe and discuss the roles that simple examples like these might play – both positive and negative – in contributing to this lack of acceptance and penetration of the DOE techniques in practice. For example, is there obviousness to the conclusions of these simple examples that might actually contribute to hurting people’s perceptions of DOE? In providing such simple examples, do we sometimes actually inhibit management’s ability to properly visualize the true value that DOE could provide in more realistic (and therefore complicated) situations? Do these types of examples help support the required early learning, and, if so, are there typically articles out there that support learning at the next level of complexity? Try to draw a conclusion about why DOE isn’t practiced more widely in most workplaces.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, kevin72836
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
image
Engineering, 04.07.2019 18:10, mamasbug4285
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
image
Engineering, 04.07.2019 19:10, kayleeemerson77
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
image
Engineering, 04.07.2019 19:20, GusGus11
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Consider the simplicity of these two DOE examples. Next, consider the assertion that DOE isn’t put i...

Questions in other subjects:

Konu
Mathematics, 04.04.2020 08:35
Konu
Mathematics, 04.04.2020 08:35